The first step is to flush the entire body of the car starting from the very top to the parts that are not readily visible to the eye. Such parts grille slit on the front of the car display. Spray that can fade faster dust and sand attached to the car body.
After that, mix the water with a special shampoo that can be found in the car aftermarket with the recommended dose of each of the shampoo manufacturer. Then input the cork or sponge into the mixture and start the upper body and then down to the bottom, including the glass. "Do not forget to clean the bird droppings and tree sap hardens," says Rizky again.
Now, for the hard parts like slit grille, bumper and connecting parts can use a brush and occasionally sprayed with water. After that proceed rinse with water that starts from the top first. Do not forget to rinse the results instantly dry with a cloth that easily absorbs water up into the crevices of the cabin door including the bottom of the car door. Do not wait too long so as not to leave residual water dried granules
0 comments:
Post a Comment